CSL 450 - Connecting via Bluetooth

19
English
as when switched-o. The hands-free funcon cannot be used when it
is turned o.
7 Connecng via Bluetooth
Ensure the headset is switched o rst. Press and hold the on/o buon
for about 6 seconds ll the LED indicator starts to ash in red and blue
alternately. Enable the Bluetooth on the device that you want to connect
with the headset. Carry out a search now and connect to the device "CSL-
450". Enter "0000" if you are prompted for a security code.
Note: The Bluetooth pairing mode is disabled for security reasons if con-
necon is not established even aer several minutes. Please carry out the
steps menoned above once again if pairing failed.
Please proceed as follows to connect two devices at the same me to
your CSL-450 headset: Connect your rst device to the CSL-450 headset
as usual. Then press the "Increase volume" and "Decrease volume" but-
tons simultaneously to use the funcon for connecng the headset to
two devices. Then, search for the model "CSL-450" on your Bluetooth en-
abled device. Here, the device that was paired rst always has priority. If
it is disabled, then you can also make phone calls or play music with the
second device.