All-In-One ESS Energy Storage System
Fail to comply with the local safety regulations (VDE for DE, SAA for AU);
Transport damage (including painting scratch caused by rubbing inside packaging during shipping). A
claim should be made directly to shipping or insurance company in this case as soon as the
container/packaging is unloaded and such damage is identified;
Fail to follow any/all of the user manual, the installation guide and the maintenance regulations;
Improper use or misuse of the device;
Insufficient ventilation of the device;
The maintenance procedures relating to the product have not been followed to an acceptable standard;
Force majeure (violent or stormy weather, lightning, overvoltage, fire etc.);Damages caused by any
external factors.
NOTE:
Please be cautious unpacking the battery, otherwise components could be damaged.
1.10 Installation Site and Environment
General
This energy storage system is indoor version and can be installed in an indoor location.
When product systems are installed in a room, product must not be hampered by the structure of the
building, the furnishings and equipment of the room.
The product is naturally ventilated. The location should therefore be clean, dry and adequately
ventilated. The mounting location must allow free access to the unit for installation and maintenance
purposes, and the system panels must not be blocked.
The following locations are not allowed for installation:
habitable rooms;
ceiling cavities or wall cavities;
on roofs that are not specifically considered suitable;
access / exit areas or under stairs / access walkways;
where the freezing point can be reached, such as garages, carports or other places as well as wet rooms
(environmental category 2);
locations with humidity and condensation over 90%;
places where salty and humid air can penetrate;
seismic areas - additional security measures are required;
Sites with altitude below 2000m;
places with an explosive atmosphere;
locations with direct sunlight or a large change in the ambient temperature;
places with flammable materials or gases or an explosive atmosphere.
1.9 Installation
This Manual introduces the basic steps to install and set up product
6
To Next Page
Loading...