Page 2-C
1. Transporting your Unit
1.1. Inspect all equipment for damage that may have occurred during shipment. Contact Cincinnati Sub-Zero
immediately if any shipping damage is noticed.
1.2. A forklift should be used to remove the unit from the skid.
1.3. The unit is to be lifted from the side as shown in the illustration below:
1.4. Forks should extend past the other side of the chamber to prevent damage.
1.5. The rear of the chamber is heavier than the front, use caution when lifting.
1.6. The chamber should be 2”-3” off the floor when transporting.
1.7. The unit is also equipped with casters and can be moved manually once removed from the skid.
2. Getting to know your Chamber
2.1. General Layout
To Next Page
Loading...