Page 3-C
2.2. Model Number Break Down: The serial number and model number can be found on the data tag.
3. Select your chamber’s location
3.1. The location must be smooth and level with a maximum slope in any direction of 1/8” (3 mm) x 10’ (3 m).
3.2. For proper ventilation a minimum clearance of 12” (31 cm) must be maintained around the sides of the
chamber and 30” (70 cm) of clearance at the back of the chamber. It is recommended to maintain a 36”
(91 cm) clearance around the chamber for ease of service access.
To Next Page
Loading...