REPLACEMENT TURRET
ENCODER
EN1 – EN2
Remove the two screws on the turret but don’t remove
The two screws on the encoder to avoid having to restore the pre-charge
Screws to remove
After tightening the screws the encoder will again be in the correct position,this system
was created to eliminate mechanical coupling problems between encoder and ball
bearing
WARNING:MAKE THE MAINTENANCE WITH
ENGINE AND PTO OFF
TO MAKE THE RESET FOLLOW THE RELATING CHAPTER
WHO CAN PERFORM THE MAINTENANCE:
TOOLS:5mmKEY
13mm KEY
TO RECOGNIZED THE DAMAGED SENSOR
FOLLOW THE ALARM LIST
pag 8
To Next Page
Loading...
