ADJUSTING MICROSWITCH
ON STABILIZER “A”
S1-2-3-4
EXTERNAL
St 1-2-3-4
MIN STABILITY
Sr 1-2-3-4
INTERNAL
Sr 1-2-3-4 on configuration “A+A”
Are the microswitch for the stabilizer on rest position
St 1-2-3-4 on configuration “A+A”
Are the microswitch for the min.stability
S1-2-3-4 nella configurazione “A+A”
Are the microswitch e stabilizer on ground position
1ADJUST THE MIN. STABILITY MICROSWITCH AFTER REPLACING:
INCORRECT ADJUSTING MAY CAUSE MALFUNCTION OR BREAK
2 THE MICROSWITCH FOR THE STABILIZER IN GROUN POSITION ARE NOT PRESSED
WHEN THE STABILIZER TOUCH THE GROUND
3 THE MICROSWITCH FOR THE REST POSITION OF STABILIZER ARE PRESSED WHEN THE
STABILIZER IS CUT OFF FROM THE GROUND
pag 10
To Next Page
Loading...
