CTI 2500-C300 - Page 4

CTI 2500 Installation and Operation Guide V2.8 iv
REVISION HISTORY
V1.27
9/17/15
Corrected error in Appendix C; CIDR notation for subnet mask
255.255.240.0.
V1.28
11/30/15
Corrected error in firmware update error table for error E30
Revised text for firmware update error E31 to improve clarity.
V1.29
3/1/2016
Expanded firmware update status codes to include Profibus FPGA (Rev
G and above)
Expanded firmware update error codes to include Profibus FPGA (Rev G
and above)
V2.0
8/25/2016
Added compact PLC (2500C-Cxxx)
Implemented table of contents hyperlinks
V2.1
1/3/2017
Corrected version support for TISOFT.
V2.2
1/26/17
Corrected illustration of user jumper (p26)
Updated copyright date
V2.3
2/6/2017
Modified properties of user jumper illustration to correct text positioning.
Added caption to open Jumper illustration.
V2.4
2/14/2017
Added inline SFP to the potential causes of fatal error 113 in Section
9.3.2.
V2.5
2/27/2017
Revised description for error E30.
V2.6
8/23/2017
Replaced dipswitch position picture for compact controller models
V2.7
12/11/2017
Added documentation for STW300 – STW330
V2.8
4/24/2018
Added a note to Appendix B stating that status words 243 and above are
not supported by Siemens 505 controllers.
Revised note in Firmware Update section that appeared to limit supported
SD cards to 4GB and below