CTM LYNG Microsafe M Komfy User Manual

NB! If none of this helps, turn the fuse for
the stove off and on.
You will then have power for the stove for
24 hours. Contact your electrician, and
he will sort out the issue.
LED
Control button
Beeper
Alarmsituations
1012
Alarm Too high temperature
Alarm indication Three beeps every 5 seconds for 40 seconds (and flashing
of red LED).
Measure Press control button - gives five minutes to ”fix” the problem
/ change status.
Alarm Timing Alarm (After 2 hours of use)
Alarm indication One beep every 30 seconds for 5 minutes before
disconnection.
Measure Press control button - provides 30 new minutes of
operation.
Alarm When the stove / cooktop is without power
Alarm indication Stove / cooktop is ”dead”.
Measure Press control button (Note: If this does not work, replace the
battery. See below).
Alarm In the need of battery replacement
Alarm indication Two beeps every minute.
Measure Pull the sensor against you (releasing it from the bracket).
Remove the two screws in the bottom cover, and replace
batteries (Two AAA-batteries). To ensure operation you have
15 minutes to replace batteries.
Applies only to Mkomfy 16R/25R (wireless model)
Quickreference for stove guard
manufacturer
CTM Lyng AS
Tel: +47 72 83 16 11
http://www.ctmlyng.no

CTM LYNG Microsafe M Komfy Specifications

General

Brand	CTM LYNG
Model	Microsafe M Komfy
Category	Security System
Connectivity	Wireless
Power Source	Battery
Features	Motion Detection, Remote Control, Alarm Siren

Summary

Alarmsituations

High Temperature Alarm

Alerts with beeps and flashing LED; press button for 5 min to resolve.

Usage Timer Alarm

Beeps every 30s before disconnection after 2 hours; press button for 30 min more use.

No Power Alarm

Indicates stove/cooktop is 'dead'; press button or replace battery if needed.

Low Battery Warning

Two beeps per minute; replace batteries within 15 minutes.

Product Test Procedure

Step 1: Enable Sensor

Set the internal slide switch 4 to ON for testing. Factory setting is OFF.

Step 2: Activate Sensor Beep

Press control button; sensor will beep every two seconds to confirm activation.

Step 3: Test High Temperature Shutdown

Point sensor at forehead; unit should turn off as temperature exceeds 30°C.

Step 4: Test Low Temperature Activation

Point sensor at cool surface; unit should turn on as temperature drops below 30°C.

Final Test Step: Reset Switch

Set slide switch 4 back to OFF before reattaching cover and reinstalling sensor.