11se c t i O n 4 — as s e M b l y & in s t a l l a t i O n
Open Hood by pushing in on the rear, right-side tab with 7.
your right hand, as seen in 1 of Fig. 4-14, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
Install the bag assemblies onto the bag support brackets 8.
by inserting the front edge in first, as seen in Fig. 4-15, and
setting the back edge down until it fits into the assembly.
Slide the hinge pin into the hole located on the mounting 6.
tab, as in Fig. 4-12. Use the cut-out window (See inset in
Fig. 4-12) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Fig. 4-13.
Figure 4-13
Figure 4-12
Figure 4-14
Figure 4-15
To Next Page
Loading...
