Cub Cadet XT Series User Manual

START BY LAYING OUT THE PARTS.
ALWAYS READ YOUR OWNER’S
MANUAL.
MOUNT ASSEMBLY ON TRACTOR
a. Place hooked ends of the mounting assembly over
the shoulder bolts, use the clevis bolt and hairpin clip
to secure bracket to tractor
INSTALL HANGER ASSEMBLY
a. Use hanger position C, secure using the carriage bolt
and wing knob
b. Place hanger assembly onto the upright support
bracket, secure using two carriage bolts and two
1/2” lock nuts and washers
ASSEMBLE MOUNTING BRACKETS
a. Attach the two side brackets to the rear attachment, use
two carriage bolts and the wing knobs to secure them
b. Flip over the assembly and mount the hitch support
bracket, use the holes furthest away from the rear
hooks and use two carriage bolts and the wing
knobs to secure them
XT™ SERIES BAGGER
ASSEMBLY GUIDE
HOW TO ASSEMBLE THE DOUBLE BAGGER ON AN XT™ LAWN TRACTOR
1
2
3
4
(CONTINUED ON NEXT PAGE)

Cub Cadet XT Series Specifications

General

Brand	Cub Cadet
Model	XT Series
Category	Lawn Mower Accessories
Language	English

Summary

Lay Out Parts and Read Manual

Assemble Mounting Brackets

Attach Side Brackets

Attach two side brackets to the rear attachment using carriage bolts and wing knobs.

Mount Hitch Support Bracket

Mount hitch support bracket using holes furthest from rear hooks, carriage bolts and wing knobs.

Mount Assembly on Tractor

Secure Bracket to Tractor

Place hooked ends over shoulder bolts, use clevis bolt and hairpin clip to secure.

Install Hanger Assembly

Use Hanger Position C

Use hanger position C, secure using the carriage bolt and wing knob.

Place Hanger onto Upright Support

Place hanger assembly onto upright support bracket, secure using carriage bolts, lock nuts, and washers.

Assemble Remaining Bagger

Snap Upper Chute Support

Snap the upper chute support into place.

Slide Left Side into Support

Slide the left side into the upper chute support using the tabs.

Align Cover Tabs and Insert Hinge Pin

Align the cover tabs with the chute support, slide hinge pin in place.

Add the Bags

Add the bags to the assembled unit.

Install Chute

Install Boot Rod Mount

Install the boot rod mount using the 7/16" nuts (2 wrenches are used).

Secure Boot Rod to Deck

Slide the boot rod into the deck, secure the boot with a wing knob.

Slide Chute into Opening

Slide the chute into the opening, turn counter-clockwise until secure.