Cub Cadet 2082 User Manual

FRONT WHEEL ADJUSTMENTS
Check the front wheels to ensure that the turning
radius of the unit is equal in both directions. Turn the
wheels all the way to the left. Measure the angle of
the wheel to the frame. Turn the wheel all the way to
the right and repeat the measurement. The angles
shall be equal.
NOTE
Power steering components are under
hydraulic pressure. If not properly adjusted,
serious damage may occur to steering com¬
ponents.
For adjustments on front wheels, see your authorized
Cub Cadet dealer.
PIVOT BAR ADJUSTMENT BOLTS
A CAUTION
The tractor must be checked every 50 hours
of tractor operation for play between the
front axle and the pivot bar adjustment bolts.
The adjustment bolt heads must fit against
the front axle. If play is discovered, the pivot
bar adjustment bolts must be adjusted.
If play is discovered between the front axle and the
pivot bar adjustment bolt heads, adjust both bolts as
follows: (See Figure 29.)
1. Loosen jam nut 3 to 4 turns or as required.
2. Turn both pivot bar adjustment bolt counterclock¬
wise until they hit against the front axle.
3. Tighten jam nut.
4. Repeat the above steps for the other pivot bar
adjustment bolt.
CARBURETOR ADJUSTMENTS
A WARNING
if any adjustments are made to the engine
while the engine is running (e.g., carbure¬
tor), disengage all clutches and blades.
Keep clear of all moving parts and be careful
of heated surfaces and muffler.
A WARNING
To avoid injury or an accident, engage single
pedal brake lock, place speed control lever
in neutral and make sure equipment is
disengaged before starting engine to make
carburetor adjustments.
A WARNING
Carbon monoxide fumes can be fatal! Do
not make any adjustments to the carburetor
in a confined area such as a storage build¬
ing. Move the tractor outside into the air.
NOTE
In this manual the tractors covered are
equipped with an adjustable jet carburetor.
3
Figure 29
1. Jam Nut
2. Pivot Bar Adjustment Bolts
3. Front Axle
21

Cub Cadet 2082 Specifications

General

Brand	Cub Cadet
Model	2082
Category	Tractor
Language	English