Cub Cadet GT 2544

GT 2544
SERIES 2500
OPERATOR’S MANUAL
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 [www.cubcadet.com]
PRINTED IN U.S.A.
Warning:
This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.
FORM NO. 769-01476
TRACTOR
Model Number
(9/04)

Cub Cadet GT 2544 Specifications

General

Transmission Type	Hydrostatic
Cutting Width	44 inches
Drive	2WD
Cutting Height	1.5 - 4 inches
Number of Blades	2
Tire Size (Front)	16 x 6.5-8
Turning Radius	18 inches
Tire Size (Rear)	23 x 10.5 inches

Summary

Emission Control Systems Warranty

Owners Warranty Responsibilities

Details the responsibilities of the engine owner regarding maintenance and proper use for warranty coverage.

Tractor and Deck Preparation

Safe Operation Practices

General Operation Safety

Essential safety rules for operating the tractor and mower deck.

Slope Operation

Service Information

Service Procedures

Controls and Indicators

Safety Interlock Switches

Operation

Before Operating Your Tractor

Pre-operation checks and familiarization with controls and manual.

Starting the Engine

Step-by-step procedure for safely starting the tractor engine.

Driving the Tractor

Driving on Slopes

Safety guidelines and techniques for operating the tractor on inclines.

Operating the Power Take-Off (PTO) Clutch

Adjustments

Wheel Alignment

Maintenance

Engine Oil

Details on checking, adding, and changing engine oil, including oil filter replacement.

Mower Deck

Deck Leveling Adjustments

Procedure to ensure the mower deck is level for optimal cutting performance.

Removal and Installation of Deck Assembly

Mowing

Mowing with Mulching Option

Trouble Shooting

Lubrication