Cub Cadet 2182 User Manual

Remove the throw-away-can-type filter and replace
with a new filter after the first 10 and 50 hours of
operation, and every 100 hours of operation
thereafter. The filters can be obtained through your
Cub Cadet Dealer under part number 723-3014.
To remove the filter, turn the filter counterclockwise
using an autonr»tive-type filter wrench.
Before installing the new filter, apply a coating of oil on
the filter gasket. Thread the new filter on by hand until
tight enough to seat the gasket. Loosen the fiHer.
Then turn it until the gasket contacts the base.
Tighten the filter an additional 1/2 turn. Start engine
and allow it to run for a few minutes. Shut engine off
and check for leaks; check oil level in transmission
case.
SPARK PLUGS
▲ WARNING
To avoid possible injury, be sure engine is
off and cool before making any adjustment
or repairs.
■ i^NOTE
Remove all dirt from around the spark plugs
before removing.
To remove spark plugs, always use a spark plug
wrench. Check gap after every 200 hours of opera¬
tion.
Replace a defective plug with a new plug. Set gap at
0.043 inch. (See Figure 44.) Tighten plug to 14.5-
18.1 ft-lbs. See your authorized dealer for the correct
replacement plug.
1. Spark Plug
FUEL FILTER
WARNING
Do not replace fuel filter when engine is hot.
The engine is equipped with an inline fuel filter. Visu¬
ally inspect the filter periodically. Replace yearly or
when dirty. (See Figure 45.)
LIGHTS
Refer to "SPECIFICATIONS” when replacement of
head lamp bulb or taillight bulb is necessary.
A WARNING
Do not change head lamp bulbs when hot or
when engine is hot.
A CAUTION
Do not touch glass portion ot head lamp
bulb. Touching glass portion will reduce life
of head lamp bulb.
■ i^NOTE
Prior removal of battery will ease removal
and replacement of head lamp bulbs.
To replace a head lamp bulb, refer to Figure 46 and
remove the socket from the grille by rotating socket
1/4 turn. Pull old bulb assembly from socket and
insert new bulb assembly. Place socket into grille and
turn to lock in place.
28

Cub Cadet 2182 Specifications

General

Engine Power	18 HP
Transmission Type	Hydrostatic
Blades	2
Deck Lift	Manual
Tires (Front)	16 x 6.5-8
Turning Radius	18 inches
Fuel Capacity	3.5 gallons
Drive System	2WD
Engine Model	Kohler CH18