Electric PTOClutch
Left Hand Pulley
beneath belt guard).
PTOIdlerBracket
(mounted on deck)
Model1515
_ Deck/PTO belt
Right Hand Pulley
(beneath belt guard)
Deck Idler Pulleys
Figure 28
Electric PTO Clutch
Left Hand Pulley
PTOIdler Bracket
(mounted on tractor)
/
/
Model1517
Deck belt (Bottom)
PTObelt (Top)
Right Hand Pulley
(beneath belt guard)
Deck Idler Pulley
NOTE: Left hand belt cover not shown for cladty.
Center Pulley
Self-Tapping Screws
Figure 29
ChangingTheTransmissionDriveBelt
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT: The V-belts found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the drive belt on your tractor,
proceed as follows:
• Remove the cutting deck as instructed earlier in this
section.
• After disconnecting the battery cables, remove the
battery and battery tray from beneath the seat.
IMPORTANT:When removing the battery, disconnect
the NEGATIVE (Black) wire from it's terminal first,
followed by the POSITIVE (Red) wire. Re-install in
reverse order.
27
To Next Page
Loading...
