Cub EXPLORER - Page 10

Page%10%of%25%
%
2. Taking an Upright Spigot Pole, remove the wing nut from the spigot, place the spigot through the
middle eyelet of the awning and place the wing nut back onto the spigot ensuring that the rope is
looped over it. Peg the rope down about ½ a metre out from the upright pole leaving some slack on
the rope. Extend the Upright Spigot Pole out slightly leaning it back towards the body of the camper.
Do up Wingnut Extend Centre Upright Pole & lean it back
3. Attach a Velcro Spreader, Velcro end to the Centre Velcro patch on the main tent. Extend the
spreader out to the Upright Spigot Pole and tension.
Attach Velcro Spreader to Velcro Patch on tent Extend Velcro Spreader to Centre Upright Spigot Pole
Tension out
4. Attach 2 of the Cup Spreader Poles to the centre Velcro Spreader and leave to hang with the snap
lock adjusters at the bottom ready for use later.
Hang two of the Cup Spreaders from the Centre Velcro Spreader