Cuddeback Attack IR - Setting Attack Parameters; Parameter Zero (P0) Configuration

Please see www.cuddeback.com for details. We
recommend you check our website for updates at
the beginning of your scouting season.
 8) FirmwareVersion–4numberswillbedisplayed,
  suchas0200.Thisisthermwareversion.
  TurntherotaryknobtoanewsettingorpressAto
return to the battery level display.
Setting Attack Parameters
Some Attack features can be changed by the user. Attack
can also be programmed to become a time lapse camera.
(Note - In the text that follows the underlined items are
default settings. For most users these settings are not
required and you can leave PO set to 0).
Step 0: Enable or disable parameters OR select
Time Lapse Operation
Firstyoumustenableparameters.Thisisdoneby:
 1. RotateknobtoMENU
 2. PressAuntilP0:0isdisplayed.P0indicates
Parameter Zero,whichistheparameteron/offcontrol.
 3. WhenP0:0isdisplayed,presstheBkeytoselect
  fromthese3options:
P0:0=parametersareOFFandsettodefaults
   (recommendedformostusers)
P0:1=parametersareONandcanbechanged
as desired
P0:tL = time lapse mode. Attack is put into time
lapse mode as explained later.
12