To Program the Auto On:
Turn the Function knob to PROG; the
Auto-On LED will flash. Set the time you
want coffee to begin brewing (follow Set
the Time instructions). Once complete, turn the
Function knob to AUTO ON and press the On/Off
button. The blue indicator light will come on to remind
you that the programming function is in use.
2.
4.
To start the brew cycle at the same time the
next day, make sure the Function knob is
on AUTO ON and press the On/Off button.
The blue Auto-On light will illuminate.
3.
At the programmed time, the blue On/Off
indicator light will come on, indicating that
the brew cycle is starting.
5.
To Program the Auto Off: Turn the
Function knob to AUTO OFF. Follow Set the
Time instructions to program Coffeemaker
to shut off 0 to 4 hours after brew cycle
is finished.
To Set the Time: Turn the Function
knob to CLOCK. Press and hold Hour or
Minute button until the clock begins flashing.
Hold down the Hour or Minute button to scroll
through the numbers. When desired time approaches,
release the button and press repeatedly to advance one
digit at a time. To finish, wait for the numbers to stop
flashing.
1.
PROGRAMMING
QUICK REFERENCE GUIDE
12-Cup Programmable Coffeemaker
& Hot Water System
Please see reverse side for setup and use instructions.
To Next Page
Loading...
Need help?
General
