QUICK REFERENCE GUIDE
SETUP AND USE: Hot Water System
2.
Fill the water reservoir with cold water
to the maximum fill line.
3. 4.
Fully immerse the charcoal water filter in
cold tap water and soak for 15 minutes (see
complete instructions on page 7 of your
Instruction Booklet). Insert filter into the
water filter holder. Open the water reservoir and insert
filter into the unit.
1.
IMPORTANT!
Do not throw away. Read before
operating your new coffeemaker.
Keep for further reference.
These helpful hints are intended to be
a supplement to the Instruction Booklet.
In order to ensure proper operation and
optimum performance, please read the entire
Instruction Booklet.
Press the On/Off button on the Hot Water
side of the unit. The green indicator light
next to Water Ready will flash during
heat-up, and will stop flashing when water
has reached temperature and is ready.
Move safety switch left to unlock. Place a
cup on drip tray and press the lever down.
The unit will dispense 10 oz. of hot water at
a time. NOTE: Hot Water System works
independently of Coffeemaker; it can be filled and
heated before, during, or after coffee is brewing.
Helpful Hint!
We recommend flushing both
the Coffeemaker and Hot Water
System before first use.
1. Coffeemaker: Fill the water reservoir with cold
water and follow directions for using
Coffeemaker. DO NOT ADD COFFEE!
2. Hot Water System: Follow directions for using
Hot Water System, then dispense all hot water to
ush the system.
You are now ready to enjoy your new Cuisinart
Coffeemaker/Hot Water System!
To Previous Page
Loading...
Need help?
General
