6
BEFORE YOU BEGIN
Before using the EvolutionX
™
Cordless
Rechargeable Hand Blender for the first time,
we recommend that you wipe the unit with a
clean, damp cloth to remove any dirt or dust.
Dry it thoroughly with a soft, absorbent cloth.
Handle carefully.
NOTE: Blending shaft, whisk attachment,
and mixing beaker are NOT dishwasher safe,
refer to cleaning instructions on page 7.
Read all instructions completely for detailed
operating procedures. The batteries in your
EvolutionX
™
Cordless Rechargeable Hand
Blender have not been fully charged. Before
the first use of this appliance, the batteries
must be charged until the 3 blue LED lights
are illuminated. See Charging Your Blender/
Battery Life, below.
CHARGING YOUR
BLENDER/BATTERY LIFE
The batteries in your EvolutionX™ Cordless
Rechargeable Hand Blender have not been fully
charged. Before the first use of this appliance,
the batteries must be charged until all 3 blue
battery indicator lights illuminate. With a
full charge, your hand blender will run for
approximately 20 minutes, depending on load.
Your hand blender will be fully charged in
approximately 2 hours.
HOW TO READ
THE BATTERY LIFE INDICATOR
• When 1st light is flashing and others are
off, battery capacity is 40%.
• When 1st light is solid and 2nd light
is flashing, battery capacity is 40%-70%.
• When 1st and 2nd lights are solid and
3rd light is flashing, battery capacity
is 70%-95%.
• When Battery Life Indicator/LED Light
Bar displays 3 solid blue power lights,
battery capacity is 95%. (NOTE: 95%
charged for a lithium ion battery is
considered fully charged.)
QUICK-CHARGE FEATURE
Your Cordless Rechargeable Hand Blender
is equipped with a quick-charge feature.
If your power handle runs out of power, you
can “quick charge” your unit:
• Charge for 15 minutes to get
25 seconds of runtime.
• Charge for 30 minutes to get
1 minute and 45 seconds of runtime.
• Charge for 60 minutes to get
5 minutes and 45 seconds of runtime.
• Charge for 2 hours for
20 minutes of runtime (full charge)
NOTE: Do not leave your hand blender
uncharged for an extended period of time,
as it will affect the life of the rechargeable
battery.
ASSEMBLY
BLENDING ATTACHMENT
To align the motor body housing with the
blending shaft, face the hand blender toward
you, and twist the blending shaft onto the
power handle until you hear it click into place.
WHISK ATTACHMENT ASSEMBLY
Align the power handle with the assembled
whisk attachment and twist the pieces
together until you hear and feel them
click together.
NOTE: Whisk and gearbox
are detachable from one another.
To Next Page
Loading...
