19
Follow these steps to de-scale
your unit:
1. Empty the reservoir.
2. Disable the AUTO OFF and OFF TIME
features.
3. Making sure there is no capsule in the
brewing chamber, fill the reservoir with
20 oz. of white vinegar, plus 40 oz.
of water.
4. Place a large mug on the drip tray.
Press and hold the HOT WATER and
RINSE buttons to start the de-scale
process. Discard contents of mug.
5. Repeat Step 4 until ADD WATER is
displayed on the control panel.
6. Rinse the water reservoir thoroughly
and fill with fresh water.
7. Run another Hot Water cycle
(see page 11). Discard contents
of large mug.
8. Repeat hot water process until
ADD WATER is displayed on the
control panel.
9. You may need to perform additional
Hot Water cycles if you detect any
residual vinegar taste.
Note: If DE-SCALE is still displayed on
the control panel after completing the
procedure, repeat the de-scaling
procedure above.
Maintenance: Any other servicing should
be performed by an authorized service
representative. Contact Cuisinart Consumer
Service Center, 1-800-726-0190.
To Next Page
Loading...
