HI-FLO
®
3
FULLY AUTOMATIC WATER SOFTENERS
SPECIFICATIONS AND OPERATING DATA
1 Exchange capacities based on treating water containing 10 grains per gallon (171 mg/L) of hardness (expressed as calcium carbonate), free of color, oil, turbidity
and at a service flow rates not exceeding 20 gpm per square foot (49 m
3
/m
2
/min) of bed area. These are nominal capacities and will vary with influent water
characteristics, temperature, pressure and other factors.
2 Operation of a softener at peak flow rate for extended periods of time may result in a slight reduction of softening capacity. This is due to premature hardness
breakthrough.
NOTE: Operational, maintenance and replacement requirements are essential for this product to perform as advertised.
Specifications are shown for single models. Duplex models have two softener tanks and one brine tank system.
Commercial Systems
©2000 Culligan
1-800-CULLIGAN
www.culligan.com
Printed in USA 4/00
DCO 992587
SL-0074
Moore Part No. 46944
Single Exchange Capacity
1
Service Flow Rates
2
Tank @ Salt Dosage
Peak Continuous Softener Brine Approx.
Press. Press. Pipe Resin Tank Tank Ship.
Minimum Maximum Flow Drop Flow Drop Size Qty. Size Size Weight
gr @ lb gr @ lb gpm psi gpm psi in ft
3
in in lb
Model g @ kg g @ kg m
3
/hr kPa m
3
/hr kPa in L mm mm kg
HC-150 100,000/30 150,000/75 78 25 60 15 2 5 21 x 54 24 x 48 540
6,480/14 9,720/34 17.7 172 13.6 103 2 142 530 x 1,370 610 x 1,200 460
HC-210 140,000/42 210,000/105 76 25 58 15 2 7 21 x 69 24 x 48 640
9,070/19 13,600/48 17.2 172 13.2 103 2 198 530 x 1,750 610 x 1,200 290
HC-300 200,000/60 300,000/150 85 25 65 15 2 10 24 x 72 30 x 48 865
12,960/27 19,400/68 19.3 172 14.7 103 2 284 410 x 1,830 760 x 1,200 395
HC-450 300,000/90 450,000/225 100 25 75 15 2 15 30 x 72 30 x 48 1,250
19,440/41 29,160/102 22.7 172 17.0 103 2 426 760 x 1,830 760 x 1,200 570
To Next Page
Loading...
