EasyManua.ls Logo

Culver Mobility ARTEMIS - Handlebar and Handbrake Adjustment; Chargers and Batteries; Charging Procedures

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
01
9^ As shown in figure 9
When the two fixing screws of the
handbrake are re 1 axed, the tightness
of the handbrake and the angle of the
hand 1 e can be adjusted to the ideal
position to tighten the screw to fix
the
handbrake (figure).
10^ chargers and batteries
Just
Step
follow the procedures below to complete the charge
1 : Check the charger socket to make sure i t i s not blocked.
Step
Step
2: Make
3: Plug
sure the wheelchair switch i s off.
the charger* s output into a slot be 1ow the control1 er.
Step 4: When the charger is green, the battery is charged, the charger* s output
Step
5: pull
plug from the slot above the battery case.
After recharging, the charger is connected to the hot spot and can be
charged for up to 24 hours, which ensures that the battery is fully charged.
When the charger is disconnected, remember to unplug the wires connected to
the control 1 er so that the power is not lost. When the wheelchair is not in
use, please charge it once a month in case the battery life is shortened.

Related product manuals