Culver Mobility ARTEMIS - Component Listing; Electromagnetic Compatibility Statement; Product Composition and Cables; EMC Performance and Interference Resolution

01
2
Control1 er
50A
1
3
Storage battery
12Ah
2
4
Fuse
0. 5A
1
5
Tires
WT-100W
406mm;254mm
Two each
WT-100WA
406mm;254mm
Two each
WT-100WB
559mm;254mm
Two each
17. Electromagnetic compatibi1ity statement
This product has passed the electromagnetic compatibi1ity test, to meet the YY 0505 standard of medical devices
and equ i pment restrict ions. These restrictions provide reasonab1e protection against harmful interference in typical
medical instai 1 ations.
®. Product composition (electrical control system)
Serial number
Part Name
Model Spec if icat ion
1
Direct current motor
EC82N245325A
2
Storage battery
50A
3
Controller
50A
②.Product cable
Serial number
Cable Name
Spec i f i cat i ons
Whether or not to block
1
Power Cord
0.7 5mm2
No
③.EMC performance
The equipment may be subject to radio frequency interference caused by other medical equipment and radio
communication. In order to prevent such interference, the product has been tested according to YY 0505-2012 and its
requirements have been met. However, the company does not guarantee that there will be no interference in the individual
installation environment. If the equipment is found to be subject to interference (which can be determined by turning i t on
and off) , the user (or qual if ied maintenance person) shal 1 attempt to take one or more of the following measures to
resolve the interference:
a) To adjust the direction or position of the emitting device;
b) Increase the distance between the device and the emitting impact device;
c) Supply power to the equipment from a power source other than that used to affect the equipment;
d) Consult with the supplier or service representative for additional advice.
The manufacturer shall not be liable for any interference caused by:
a) UseInterconnection cables other than those recommended.
b) Unauthorized alteration or modification of the equipment, unauthorized alteration or modification may result in
the user's right to operate the equipment in urban areas.
All types of electronic equipment may cause electromagnetic interference to other equipment through air or other
cables connected to it. The term EMC (Electromagnetic compatibi1ity) refers to a device that is immune to
electromagnetic interference from other devices and that does not affect the ability of other devices to emit similar
electromagnetic radiation.
If the required EMC performance is not fully achieved, the user shall install the product according to the steps
described in the instruction manual. If there is any problem related to EMC, please contact the Repairman.
(4). Points for attention in product installation
1) Use The power cord provided or specif ied by the company. Products with power plugs should be plugged into a