6 PNEG-308 Purafire
1. Safety
Do Not Operate on Base
The air inlet is on the bottom. DO NOT operate this heater
while it is sitting on its base.
Electric Shock Hazard
Keep Area Clean
DO NOT permit feathers, hay, straw, dust or other combustible
materials to accumulate in, on, or around the heater. A fire may
result. Perform periodic cleaning as necessary.
Never use the heater in spaces which contain or may contain
volatile or airborne combustibles, or products such as gasoline,
solvents, paint thinner, dust particles or unknown chemicals.
Failure to follow these instructions may result in fire or explosion,
property damage, personal injury or death.
The surfaces of this heater may be hot. DO NOT touch.
Fire Hazard
Hot Surface
Install and Operate Electrical
Equipment Properly
Electrical controls should be installed by a qualified electrician
and must meet the standards set by the National Electrical Code
and all local and state codes.
Disconnect and lock out all power sources before installing
wires/cables or servicing equipment.
Electric Shock Hazard
To Next Page
Loading...
