In pockets one and two, use a
microfiber towel or vacuum to clean
the stacker mirror located directly across
from the stacker-sensor lens.
12
Replace feeder plate. Insert curved
edge of feeder plate first. Gently
press down on feeder plate until it snaps
into position.
Curved edge
13
Replace hopper.
14
Clean remaining hard-plastic
exterior surfaces as necessary
with a Simple Green Safety Towel.
Carefully reconnect power cord.
Turn power ON (rocker panel to I).
Perform a test run with some notes.
Clean the touch-panel display with a dry microfiber towel.
16
17
18
19
15
Avoid damaging touch-panel display.
Only clean touch-panel display with dry microfiber
towel as directed.
To Next Page
Loading...
