To Next PageTo Next Page
Need help?Do you have a question about the CUMMINS ISM CM570 and is the answer not in the manual?
General| Engine Model | ISM CM570 |
|---|---|
| Manufacturer | Cummins |
| Category | Industrial Equipment |
| Engine Type | Diesel |
| Number of Cylinders | 6 |
| Displacement | 10.8 liters |
| Aspiration | Turbocharged |
Verify engine conditions, oil level, and inspect for leaks. Interview operator regarding fault occurrence.
Repair or replace components found out of specification or the source of leaks.
Verify correct oil drain interval is followed and check oil consumption logs.
Visually verify the correct lubricating oil filter is installed for the engine.
Check oil level on a level surface with engine off. Address high/low levels and contamination.
Inspect the lubricating oil pressure relief valve to determine if it meets specification.
Monitor oil pressure and compare sensor reading with a mechanical gauge.
Measure differential pressure across the filter. Replace if plugged or maintenance interval missed.
Pressure test the oil cooler and visually inspect housing and element for leaks or damage.
Check oil for contamination. Replace filter and change oil if deposits or contamination observed.
Inspect the oil suction tube and o-ring for damage. Replace if damaged.
Inspect the main lubricating oil pressure regulator assembly for damage. Replace if necessary.
Inspect the lubricating oil pump for damage, loose, or worn gears. Replace if necessary.
