WWW.CURRENT-USA.COM
5
Installation Instructions
Congratulations on purchasing your new Satellite Lighting System
Please carefully read all instructions and warnings below and enjoy your new lighting system.
In order to validate your warranty, please fill out the enclosed registration card or go online to our
website http://www.current-usa.com to register your product electronically.
Note: Read all instructions and warnings listed within this manual.
Please also read all warnings affixed to the fixture.
Instructions
• Carefully remove the lighting fixture from packaging.
• Remove acrylic splash lens and remove plastic lens protector and packaging material
around the lamps.
• Make sure lamps are firmly inserted into sockets. Replace acrylic splash lens.
• Plug the power cords into GFCI outlets.
• If you wish to use automatic light features, plug the power cords into timers before plugging into
the GFCI outlet. If you wish to create a dawn and dusk effect, for Dual Lamp systems only, plug
each power cord into separate timers.
• Apply the four rubber feet supplied to the underside of the fixture to elevate the fixture above the
aquarium 1/4”. You may also use the elevating brackets (CURRENT part #1000 sold separately)
to elevate the fixture above your aquarium. DO NOT place fixture underneath a canopy or hood.
Light fixtures are to be place on top of completely covered aquariums.
• Do not operate fixture if any of the electrical connections have become damaged or corroded.
• Do not allow water to come in contact with the fixture. Use on completely covered aquariums
and do not remove acrylic lens.
• Inspect once a month and remove any visible signs of salt build up.
Enjoy your new Satellite Lighting System.
To Next Page
Loading...
Need help?
General
