Maintenance
Changing
the
Internal Light
1.
Before carrying
out
the
bulb
replacement always
adjust
the
thermostat
control dial
to
Position
0,
then
disconnect
the
mains supply.
2.
To
change
the
light
bulb
(220-240, max. 15W),
undo
the
screw.
3.
Press
the
light
bulb
cover
as
shown and slide
it
backwards.
4.
Change
the
defective
light
bulb.
5.
Refit
the
light
bulb
cover and
the
screw.
6.
Put
the
refrigerator back
into
operation.
Care When Handling I Moving Your Unit
Hold
the
unit
around its sides or base when
moving
it. Under
no
circumstances should
it
be
lifted
by
holding
the
edges
of
the
top
surface.
Servicing
The
unit
should be serviced
by
an authorised engineer and only
genuine
spare parts should
be
used. Under no circumstances should you
attempt
to
repair
the
unit
yourself. Repairs carried
out
by
inexperienced persons may cause
injury
or serious malfunction. Contact a qualified
technician.
Switching Off for Long Periods
ofTime
When
the
unit
is
not
in use
for
a long period
of
time, disconnect
it
from
the
mains supply,
empty
all
food
and clean
the
appliance, leaving
the
door
ajar
to
prevent unpleasant smells.
Disposal
Old units still have some residual value. An environmentally friendly
method
of
disposal will
ensure
that
valuable raw materials can be recovered and used again. The refrigerant used in
your
unit
and insulation materials require special disposal procedures. Ensure
that
none
of
the
pipes on
the
back
of
the
unit
are damaged
prior
to
disposal.
Up
to
date information concerning options
of
disposing
of
your
old
unit
and packaging
from
the
new
one can be obtained
from
your
local council office.
When disposing
of
an old
unit
break
off
any old locks or latches and remove
the
door
as
a
safeguard.
12
To Next Page
Loading...