• Allow the unit to stand upright for at least 2 hours before connecting it to the
mains.
• Do not cover or block the sides of your wine cooler.
Installation
Location
When selecting a position for your unit make sure the floor is flat and firm, and that the
room is well ventilated with an average room temperature of between 16°C and 32°C. Avoid
locating your unit near a heat source, e.g. a cooker, boiler or radiator. Avoid direct sunlight.
If you are placing your unit in an outbuilding such as a garage or annex ensure that the unit
is placed above the damp course, otherwise condensation will occur on the cabinet. Never
place the unit in a wall recess or into fitted cabinets or furniture.
Levelling the Unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
Installing the Spacers
Screw the spacers at the rear of the wine
cooler.
Free Space Requirements
When installing the unit, ensure that
25mm of free space is left at both sides,
50mm at the rear and 25mm at the top
of the unit. This will allow cold air to
circulate around the wine cooler and
improve the efficiency of the cooling
process. The door can open to the right
or the left, depending on which best
suits the location. Please ensure there
is adequate space for the door to fully
open.
screw
7
CWC15B14_IB_Final140122.indd 7 22/01/2014 9:19 PM
To Next Page
Loading...