Curtis 1605 - Connecting Charger to Battery; Plugging in the Charger

8
STEP-BY-STEP GUIDE FOR USE
1. Connecting Charger to Battery
Connect the charger output connector to the
vehicle or battery connector
2. Plugging-in Charger
For the 120V model: plug the AC line cord into an outlet
supplying 108 to 132 VAC, 57 to 63 Hz power.
For the 230V model: plug the AC line cord into an outlet
supplying 216 to 255 VAC, 47 to 53 Hz power.
After a few seconds, the Red and Yellow indicators
should light up.This indicates that charging is in process.
If the Yellow indicator is flashing, there may be a
problem with the battery, or the battery connection (broken
wire or connector not plugged in). Try unplugging the charger
from the AC outlet and correcting the battery connection, then
go back to STEP 1.
!