Curtis G3 ThermoPro TP2T10A3100 User Manual

Label style may vary
Label style may vary
Entering
Programming Mode
Enter Code
- - - -
Wilbur Curtis
Wilbur Curtis
Ready to Brew*
Global Recipes
<-- Select -->
Language
<-- Select -->
Non-Brew Prog
<-- Select -->
Brew Button Prog
<-- Select -->
Model Select
<-- Select -->
Exit
<-- Select -->
Program menus
<-- Select -->
Program Menus
<-- Select -->
See Global
Recipes Menu
section
See Brew Button
Programming Menu
section
See Model
Select Menu
section
See
Language Menu
section
See Non-Brew
Programming Menu
section
Press
~
Press
~
Press
~
Press
~
Press
~
Press
~
* “Ready” on some models
With unit OFF, press and hold
bottom right BREW button (4).
Then press and release
ON/OFF button (2). Continue to
hold down BREW button until
Enter Code appears.
Enter 4 digit code.
(factory default = 1-2-3-4)
To enter programming mode:
PROGRAMMING GUIDE PG2
IMPORTANT: All programming functions are performed
with the three center buttons.
The symbols below the buttons are:
 Ż Scroll LEFT/UP (1)
~ SELECT or ENTER to save new parameter (2)
Ź Scroll RIGHT/DOWN (3)
Once you enter programming mode, press
Ż or Źto scroll LEFT
or RIGHT to the various menus (Global Recipes, Non-Brew Prog,
Brew Button Prog, etc.). Press ~ (SELECT) to enter a menu. Then
press
Ż or Źto scroll UP or DOWN through a menu. When the
desired menu item appears on the screen, press ~ (SELECT) to
access. See Programming Options for detailed descriptions.
8$130(3"..*/((6*%&ø H

Curtis G3 ThermoPro TP2T10A3100 Specifications

General

Brand	Curtis
Model	G3 ThermoPro TP2T10A3100
Category	Brewing Systems
Language	English