Curtis G3 ThermoPro TP2T10A3100 User Manual

INSTALLATION INSTRUCTIONS II11
Installing the Power Plug (units that do not have a
pre-installed plug and will be connected to a power
receptacle)
10 Connect the appropriate type of grounded power plug
to the end of the power cord coming from the back of
the unit.
Powering up the Unit
Units Operating with a power plug:
11 Connect the power plug to the appropriate type of
electrical outlet.
All Units:
12 Turn on the water supply valve.
13 Make sure that the circuit breaker supplying power to
the unit is on.
14 Turn the toggle switch on the back of the brewer to the
0/QPTJUJPO5IFXBUFSUBOLXJMMTUBSUUPmMM8IJMFUIF
UBOLJTmMMJOHJOTQFDUUIFXBUFSTVQQMZMJOFGPSMFBLT
Connect the Brewer Wiring (cont.)
WARNING: Connect the power cord to the
appropriate type and size electrical outlet. If the
electrical outlet is not compatible with the power
cord, have it upgraded by a licensed electrician. Do
not modify the power plug. Do not use an extension
cord. Do not use a power cord/plug that is damaged.
(5)&3.0130.*-"/0*/45"--"5*0/*/4536$5*0/4ø 092519E
Back of brewer
Required plug style
varies with circuit
requirements
15 On models that do not come with the control panel
label installed, determine if the brewer will be setup
for one, two or three batch mode. Find the appropriate
label, included with the brewer. The three batch label
IBT-"3(&.&%BOE4."--#3&8POJUUIFUXP
CBUDIMBCFMIBT-"3(&BOE4."--#3&8POJUBOE
UIFPOFCBUDIIBTPOMZ#3&8POJU1FFMUIFQSPUFDUJWF
CBDLJOHPGGPGUIFEFTJSFEMBCFMBOEBGmYJUUPUIFGSPOU
of the universal control module (UCM). Go to the
PROGRAMMING GUIDE section and program the
brewer for the correct model and batch number.
continued...

Curtis G3 ThermoPro TP2T10A3100 Specifications

General

Brand	Curtis
Model	G3 ThermoPro TP2T10A3100
Category	Brewing Systems
Language	English