5
1. Empty hopper of coffee beans. Run grinder to clear grinding burrs of coffee.
hear the grinding burrs starting to touch, immediately, back
coarser grind.
tighten the locknut.
5. Run some coffee beans through the machine to check the
grind adjustment.
6. Replace front cover on machine.
*This adjustment may change the amount of ground coffee
dispensed.
2. Empty the hopper of beans.
in the housing.
the shear drive.
the shear disk to break.
All mechanisms, including the motor bearings, have been oiled for life. No additional lubrication is neces-
sary.
occur to the motor if you run it on an overloaded circuit.
CURRENT
LUBRICATION
CHANGING
ADJUSTING
THE GRINDS*
1
2
8
7
5
4
3
9
10
6
To Next Page
Loading...