p/n: IM-1JD4120
INSTALLATION & OWNER’S MANUAL
The contents of this envelope are the property of the owner.
Be sure to leave with the owner when installation is complete.
CAB INSTALLATION INSTRUCTIONS
JOHN DEERE 4000 SERIES (4500/4600/4700)
(4510/4610/4710) (4120/4320/4520/4720)
HARD SIDED CAB ENCLOSURE (p/n: 1JD4120AS)
SOFT SIDED CAB ENCLOSURE (p/n: 1JD4120SS)
This Curtis Cab is designed and
manufactured for use only as reasonable
weather protection. This cab is not appli-
cable, Nor should the cab be considered as protection against
roll over, collision or other accidents that may result. This cab is
NOTaR.O.P.S.cab. Extreme care should be taken when operat-
ing and by qualified, experienced operators only.
ExposuretoCarbonMonoxidecanCause
illness,seriousinjuryordeath.Never
operate vehicle if suspicious of Carbon
Monoxide. Inspect exhaust system for leaks monthly. Leaks can
result from loose connections, corrosion, cracks or other damage
to the exhaust manifold. If leaks are found, repair or replace
exhaust system. Do not use vehicle until repair or replacement is
complete.
CABS/BLADES/ SPREADERS/ACCESSORIES
driver and passenger.
exceed the vehicles rated capacity including
from the vehicles rated capacity and never
brochures. Deduct the accessories total weight
Curtis accessory weights are listed in product
add additional weight to the base vehicle. All
Curtis Cabs, blades and general accessories
ADDED
WEIGHT
Note: 4510 shown with soft sided
cab and optional work lights and
optional strobe light.
Rev. T, p. 1 of 11
To Next Page
Need help?
General
