Before Use
For U.S.A.
Choose unit installation location carefully .Avoid placing it in direct sunlight or close to a source of heat .
Also avoid locations subject to vibrations and excessive dust , cold or moisture . Keep away from sources that hum , such
as transformers or motors .
Do not open the cabinet as this might result in damage to the circuitry or electrical shock . If a foreign object should get into
the set , contact your dealer .
Be sure not to handle discs with dirty fingers . Never insert a disc that has a crack on the surface .
When removing the power plug from the wall outlet , always pull directly on the plug , never yank the cord .
To keep the laser pickup clean , do not touch it , and do not forget to close the disc tray .
Do not attempt to clean the unit with chemical solvents as this might damage the finish . Use a clean , dry cloth .
Keep this manual in a safe place for future reference .
Beware of Condensation
When the player (or a compact disc) is moved from a cold to a warm place or is used after a sudden temperature change ,
there is the danger of condensation . Water vapor in the air could condense on the mechanism or the laser pickup . If droplets
of water form on these parts , correct playback will be impossible because the laser cannot read the information from the
disc correctly . To prevent this , if you are going to use the player in a condition where condensation could occur , you should
leave the player for 1 or 2 hours after plugging it into an AC outlet depending on the amount of condensation . If this is done ,
the player will stabilize at the temperature of its surroundings .
TO THE USER
This equipment has been tested and found to comply with the limits for a Class B digital device , pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against interference in a residential area. This device
generates and uses radio frequency energy and if not installed and used in accordance with the instructions , it may cause
interference to radio or TV reception . If this unit does cause interference with TV or radio reception you can try to correct the
interference by one or more of the following measures :
A)Reorient or relocate the receiving antenna .
B)Increase the separation between the equipment and receiver .
C)Plug the equipment into a different outlet so that it is not on the same circuit as the receiver .
If necessary , consult the dealer or an experienced radio / TV technician for additional suggestions .
CAUTION:
Changes or modifications to this equipment not expressly approved by the manufacturer for compliance could void the users
authority to operate this equipment .
2
To Next Page
Loading...