custom alarm Vista - User Manual

Disarm
Enter 4 digit code + 1 (Disarm)
Arm Stay (No Motion Sensors)
Enter 4 digit code + 3 (Stay)
(if ‘Quick Arm’ is enabled, press # + 3)
Arm Night (No Motion, No Door Delay)
Enter 4 digit code +7 (Instant)
(if ‘Quick Arm’ is enabled, press # + 7)
Arm Away (Motion Sensors On)
Enter 4 digit code +2 (Away)
(if ‘Quick Arm’ is enabled, press # + 2)
Check System Status
Press * to show if any sensors are currently open or in trouble.
Clearing an Alarm
Enter 4 digit code + 1 (Disarm) once to silence, then repeat 4 digit code + 1
(Disarm) to clear alarm and disarm fully.
Bypass a Problem Zone
•Know which Sensor (zone) is having the issue. Press * and the display will
scroll any troubled/opened zone names, along with a 2 digit number for it.
•You will need to do this command sequence once per zone number if
there are multiple sensors being bypassed.
•Once you have found your problem zone number(s), type your 4 digit code
+ 6 (BYPASS) + Zone number (03, 09, 15, 22, etc.)
•Once all open/troubled zones are bypassed, the system can be armed as
normal. The bypasses will clear upon the next disarm, and will need to be
re-bypassed when attempting to arm again.
Enable Door Chime (Keypad beeps when door opens)
Enter 4 digit code + 9 (Chime) - The display will indicate whether the
chimeisonoro.RepeatthecommandtoswitchbetweenOn/O.
Vista
Quick Reference Guide

Summary

System Operation Modes

Disarm

Enter 4 digit code + 1 (Disarm) to disarm the system.

Arm Stay Mode

Enter 4 digit code + 3 (Stay) to arm without motion sensors.

Arm Night Mode

Enter 4 digit code + 7 (Instant) for no motion or door delay.

Arm Away Mode

Enter 4 digit code + 2 (Away) to arm with motion sensors.

Check System Status

Press * to show if any sensors are currently open or in trouble.

Clearing an Alarm

Enter 4 digit code + 1 (Disarm) twice to silence and clear alarm.

Bypass a Problem Zone

Enter 4 digit code + 6 (BYPASS) + Zone number to bypass.

Enable Door Chime

Enter 4 digit code + 9 (Chime) to toggle door chime on/off.

Add Change Delete Codes

User Codes Management

Manage user codes via command sequence for adding, changing, or deleting.

Add New User Code

Add a new code for a specific user slot using Master Code + 8 + User Number + New Code.

Change Existing User Code

Change an existing user's code using Master Code + 8 + User Number + New Code.

Delete User Code

Delete a user code using Master Code + 8 + User Number + # + 0.

Change Master Code

Change the Master Code (User 02) using Master Code + 8 + 02 + New Master Code twice.

custom alarm Vista Specifications