Custom LED Blinker Genie User Manual

2011-2013 Ducati Diavel Blinker Genie
Illustrated Installation Instructions
This 100% plug-and-play kit allows for run and turn operation of the OEM pilot light assemblies 
(continued on other side)
1) Remove bolt securing side cover on right side of
motorcycle.
2) Remove two bolts securing intake grill.
3) Push intake grill to the side and remove the
10mm bolt securing radiator stay to side cover.
5) Repeat procedure on left side of motorcycle.
6) Locate the OEM blinker lamp connectors, remove
from retention slot behind shroud, and maneuver
connector down as shown. Depress locking tab and
disconnect. Repeat on both sides of motorcycle.
7) Rout long legs of blinker genie harness from
behind steering neck area down to turn signal
connectors on each side of motorcycle. Route wires
inside of frame. See next image for more details.
4) Remove side cover by sliding forward slightly, and
then lifting straight upward.
Slot behind here

Custom LED Blinker Genie Specifications

General

Brand	Custom LED
Model	Blinker Genie
Category	Motorcycle Accessories
Language	English

Summary

Blinker Genie Installation Guide

Prepare Motorcycle: Remove Right Side Cover

Remove the bolt securing the side cover on the right side of the motorcycle.

Prepare Motorcycle: Remove Intake Grill

Remove two bolts securing the intake grill and the 10mm bolt securing the radiator stay.

Prepare Motorcycle: Remove Side Cover Upward

Slide the side cover forward slightly, then lift it straight upward.

Prepare Motorcycle: Repeat on Left Side

Repeat the procedure on the left side of the motorcycle for covers and grills.

Disconnect OEM Blinker Connectors

Locate, remove, depress locking tab, and disconnect OEM blinker lamp connectors.

Route Blinker Genie Harness

Route harness legs from behind steering neck down to turn signal connectors, inside of frame.

Connect Blinker Genie to OEM Connectors

Connect Blinker Genie legs to mating connectors and position connectors into retention slots.

Route and Tuck Blinker Genie Harness

Tuck the other connector behind radiator shroud and zip tie cables together.

Disconnect Headlamp Connector

Locate the headlamp 2-wire connector, slide off mounting tab, and disconnect.

Connect Blinker Genie to Headlamp Wires

Connect Blinker Genie connectors to their mating connectors on the headlamp wires.

Reassemble Headlamp Connectors and Harness

Reattach one headlamp connector, tuck other connector and harness body inside frame.

Secure Wiring and Reinstall Covers

Zip-tie wires to prevent interference with steering, then reinstall side covers and hardware.

Final Enjoyment

Enjoy the installed Blinker Genie.