Need help?Do you have a question about the Cutler-Hammer Jonson Controls N2 and is the answer not in the manual?
Explains warning symbols and safety alert messages for hazards.
Details precautions for working with high voltage in motor control equipment.
Describes VSD Series drives controlled via N2 or XT BUS with VS-OPTNX board.
Lists technical specifications including interface, bus type, baud rate, and environmental limits.
Details the VS-OPTNX RS-485 Communication Board layout, connectors, and jumpers.
Details on connecting communication bus and grounding the cable shield.
Describes two grounding methods: clamping to frame and single-point grounding.
Explains how to set bus termination using jumper X4 for N2 network.
Explains the meaning of Yellow (RS-485 status) and Green (Fieldbus status) LEDs.
Step-by-step guide for physically installing the VS-OPTNX communication board.
Details on setting up fieldbus board and RS-485 communication parameters.
Guides on verifying software revision and configuring communication timeout settings.
Explains how to check communication status and interpret message indications.
Describes N2 interface capabilities, control, monitoring, and features for AI, BI, AO, BO, ADI points.
Provides detailed point maps for N2 Analog Inputs, Binary Inputs, Analog Outputs, Binary Outputs, and Internal Integers.
Overview of XT bus protocol, configuration using GX-9100 software for analog/digital points, and downloading.
Provides detailed point maps for XT Bus Analog Inputs, Analog Outputs, Digital Inputs, and Digital Outputs.
Describes how the fieldbus master reads VSD actual values using process data variables.
Lists and defines fieldbus parameters (M1 to G1.9) for process data selection.
General| Brand | Cutler-Hammer |
|---|---|
| Model | Jonson Controls N2 |
| Category | Conference System |
| Language | English |
To Next Page