CyberData Corporation
3 Justin Court, Monterey, CA 93940
www.cyberdata.net
P 831.373.2601 | F 831.373.4193
RING CENTRAL CONFIGURATION GUIDE: SIP PAGING ADAPTER (SPA)
Doc. 931050B Page 54
Autoprovisioning
If you are autoprovisioning the SPA, use the following steps to configure the SPA to join
multicast paging groups receiving pages from the CyberData V3.1 Paging Server and Polycom
phones.
1. Identify the multicast IP addresses and port numbers for each paging group you need to
configure. See Table 8-1 for example paging groups.
2. Set EnableMulticastOperation to Yes under MulticastSettings in the autoprovisioning
template.
3. Each MGROUP corresponds to a numbered priority, as shown on the Multicast
Configuration page in the web interface (see Figure 8-4). 0 is the lowest priority and 9 is
the highest priority reserved for emergencies. Enter the multicast IP addresses and port
numbers for each paging group according to the appropriate priority.
Figure 8-6. Autoprovisioning Example – Multicast Groups
To Next Page
Loading...
