Copyright © 2021 Cyber Power Systems, Inc. All rights reserved.
2
31
INSTALLATION GUIDE
3. Insert and tighten the
retaining screws.
4. Connect an Ethernet cable to
the Ethernet port of the
Remote Cloud Card.
2. Install the Remote Cloud
Card into the expansion slot.
1. Remove the two retaining
screws from the expansion
slot, and remove the cover.
Step 1. Hardware Installation
Definitions for the LED Indicators
Step 2. Application Installation
Install the “POWERPANEL” application available for download on
the Apple App Store or Google Play, then launch the application.
Step 4. Add a device in the POWERPANEL app
1. Click “+” in the upper right corner of the homepage, as shown in
Figure 2.
Figure 2
Figure 1
Step 3. Sign Up and Login, as shown in Figure 1
iOS Android
Tx/Rx
Link
RCCARD100
CyberPower
Tx/Rx
RCCARD100
CyberPower
QR Code
LINK Indicator Tx/Rx Indicator
Ethernet Port
Cloud
Link LED color
O
On (Yellow)
Tx/Rx LED color
O
On (Green)
Flashing
Condition
The Remote Cloud Card is not connected
to the Network/ or the Remote Cloud Card
power is o.
The Remote Cloud Card is connected to
the Network.
The Remote Cloud Card power is o.
The Remote Cloud Card power is on.
- Receiving/transmitting data packet
- Reset finished
Quick Start Guide
REMOTE CLOUD CARD
RCCARD100
REMOTE CLOUD CARD
RCCARD100
NOTE: The Remote Wireless Cloud Card is hot-swappable,
so you do not need to turn o the device to install it.
To Next Page
Need help?
General