EN
7
💡
SECURING THE CHILD
1. Route the vehicle seat belt around your child and insert the belt tongue into
the belt buckle. It must lock into place with an audible "CLICK".
2. Place the lap belt in the green coloured lap belt guides (e) of the car seat.
3. Pull the shoulder belt to tighten the lap belt.
4. On the side of the car seat next to the belt buckle, the shoulder belt and the
lap belt must be inserted together in the lap belt guide (e).
5. Feed the shoulder belt through the shoulder belt guide (f) until it is inside the
belt guide.
(b) to
change the position of the belt.
REMOVING AND REATTACHING THE SEAT COVER
The cover of the car seat consists of 3 parts. These are held in position at
several places by press-studs, velcro and elastic tapes. Once all have been
released, the single parts of the cover can be removed.
In order to put the covers back on the seat, follow the removal instructions in
the reverse order.
💡 The cover may only be washed at 30 °C with a delicate wash program
otherwise it may result in discolouration of the cover fabric. Please wash the
cover separately from other laundry and do not dry in the dryer or in direct
sunlight!
MANUFACTURER'S WARRANTY AND DISPOSAL REGULATIONS
CYBEX GmbH (Riedingerstr. 18, 95448 Bayreuth, Germany) gives you 3
years warranty on this product. The warranty is valid in the country, where
this product was initially sold by a retailer to a customer. The contents of the
warranty and all essential information required for the assertion of the warranty
can be found on our homepage
. If a warranty is shown in the article description, your legal
Please observe the waste disposal regulations in your country.
To Next Page
Loading...
