6
•
If the seat is used with the Base One the load leg must always make
compartments in the footwell, be sure to contact the vehicle manufacturer.
•
For the car seat to provide the best possible protection, always use the
linear side-impact protection (L.S.P.).
•
If using the car seat on a middle seat of the vehicle, the linear side-impact
protection (L.S.P.) must never be folded out.
•
The car seat has also been tested and approved for use without the linear
side-impact protection (L.S.P) folded out.
•
Always ensure that the car seat is not jammed against any surface when
closing the vehicle door or adjusting the back seat.
•
secured. Otherwise, they may be thrown within the vehicle, which could
cause fatal injuries.
•
The car seat must never be used without the seat cover. Ensure that
only an original CYBEX seat cover is used, as the cover is a key element
allowing the seat to function correctly.
•
Never leave your child unattended in the vehicle.
•
Do not place the car seats on raised surfaces, such as a table.
•
Parts of this child restraint system can heat up when exposed to direct
sunlight and could potentially burn your child's skin. Protect your child and
the car seat from direct sun exposure.
•
the naked eye. Please replace the car seat after an accident. In case of
doubt, please consult your dealer or the manufacturer.
•
Do not use this car seat for more than 8 years. The car seat is exposed
to high stress during its product lifespan, which leads to changes in the
quality of its materials with increasing age.
•
The plastic parts can be cleaned with a mild cleaning agent and warm
water. Never use harsh cleaning agents or bleaches!
•
On some vehicle seats made of sensitive materials, the use of car seats
may leave marks and/or cause discolouration. To prevent this, you can
place a blanket, towel or similar underneath the car seat to protect the
vehicle seat.
Thank you for deciding on the Aton S2 i-Size when choosing your car seat.
Carefully read this User guide before installing the car seat in your vehicle and
always keep it to hand in the designated compartment (28).
IMPORTANT INFORMATION AND WARNINGS
•
Without the approval of the Type Approval Authority, the car seat may not
•
In order to keep your child properly protected, it is absolutely essential that
you use the car seat as described in this user guide.
•
This car seat may only be installed on vehicle seats which are approved for
the use of child restraint systems according to the vehicle manual.
•
The car seat can only be attached with the Base One and ISOFIX, or with
a 3-point automatic belt that is approved according to UN regulation No. 16
or an equivalent standard.
•
If the car seat is installed using a 3-point automatic belt, the vehicle belt
buckle must never reach in the lap belt guide of the car seat. If the belt
whip is too long, the car seat is not suitable for use in this position in the
vehicle.
•
The installation of this car seat on the front passenger seat with the
front airbag activated is NOT PERMITTED.
•
Do not use any load-bearing contact points other than those described in
the User guide and marked on the child restraint.
•
The Newborn inlay is used to protect your child and must be used up until
your child has reached a height of 60 cm.
•
Before each journey make sure that the car seat harness system is
be twisted!
•
Always buckle up your child when it is in the car seat.
•
appropriately.
•
The car seat must always be correctly installed and secured in the vehicle
even when not in use.
CERTIFICATION
ATON S2 i-Size
Size range: 45–87 cm
Weight: max. 13 kg
EN
To Next Page
Loading...
Need help?
General
