6
Press select while the interval box is highlighted to
go to the “interval memory” mode.
The screen remains dark, and you’ll be able to check
the results of previous intervals in your ride. The
word, “memory,” appears below the interval number
to indicate you are in interval memory mode.
While in “active interval” or “interval memory” mode,
the power is always the power you’re currently
expending. Return to the normal ride screen by
pressing select while the interval box is highlighted.
You will return to your normal ride after you cycle
through your intervals.
3.6: Cadence/Speed
“Cadence” displays the number of RPM’s you’re ped-
aling and is measured by the cadence sensor on your
bicycle frame. You can press select to display the
average cadence or maximum cadence.
This box can also be used to display your speed.
Press select until you see “SPD MPH” or “SPD KPH.”
The CycleOps PowerBeam
TM
Pro computer now
monitors your current speed in miles per hour/kilo-
meters per hour. Pressing select again will measure
your average speed, and pressing it one more time
will give you your maximum speed. Press select once
more to return to cadence.
3.6.1 Using the Cadence Sensor
You must install the cadence sensor if you want to
monitor your cadence during the ride. Refer to Part 1
for installation instructions. The cadence sensor will
communicate wirelessly with the CycleOps Power-
Beam
TM
Pro
computer while you ride. The CycleOps
PowerBeam
TM
Pro
computer automatically fi nds your
cadence sensor when a workout is entered. Once
it is found, the data is displayed on the CycleOps
PowerBeam
TM
Pro computer. If none is found, the unit
will time out and stop searching. If you attach your
cadence sensor in the middle of a workout or ride,
exit and enter the ride to re-initiate the search.
Note: When the battery is changed out in the ca-
dence sensor, you will need to re-learn the device to
the CycleOps PowerBeamTM computer (see Section
5.5).
3.7: Time
This box displays your total ride time. You can also
choose to display distance by pressing the select
button.
3.8 Exiting a Ride
If you want to take a break, press and hold the mode
and select buttons for two seconds. You will be taken
to the “Ride Option” screen.
Note: Your ride data, including time and all average
calculations, will be paused.
Press “Resume” to return to the ride. “Exit” leaves the
ride and returns to the main menu. The current ride
status, data, and time are saved and can be resumed
from this point. “Find” returns to the ride and re-initi-
ates the search for heart rate and cadence sensors.
To Next Page
Loading...
Need help?
General
