CycleOps PowerBeam Pro User Manual

8
4.8: Exiting a Workout
If you need to take a break, press and hold the mode
and select buttons together for two seconds. You will
be taken to the “Ride Options” screen.
Press “Resume” to return to the workout. “Exit” leaves
the workout and returns to the main menu. The cur-
rent workout status, data, and time are saved and can
be resumed from this point. Note that only the last
workout’s status is saved and can be resumed. Other
workouts must be started from the beginning of the
workout. “Find” returns to the ride and re-initiates the
search for heart rate and cadence sensors.
Setup Mode enables you to set several options on
the CycleOps PowerBeam
TM
Pro . You can calibrate
your devices, work with memory, and change many
other features of the system. Choose “Setup” from
the Main Menu by using the arrow buttons to high-
light it and then pressing select to enter Setup Mode.
5.1: Setup Screen
When you fi rst enter Setup Mode, you will see a
screen that presents you with several options. Use
the arrow buttons to scroll down to the option you
want and press select to choose it. Each option is
explained in detail in the following sections.
5.2: Memory
This option allows you to work with the available
memory in your CycleOps PowerBeam
TM
Pro com-
puter. There are two choices on this screen.
Part 5: Setup Mode

CycleOps PowerBeam Pro Specifications

General

Brand	CycleOps
Model	PowerBeam Pro
Category	Fitness Equipment
Language	English