14
Statement of Compliance for FCC and
Industry Canada:
Saris Cycling Group, Inc.
Model #: ERUTT3
Contains transmitter SL24TT3
FCC ID: T8P-SL24TT3
IC: 6459A-SL24TT3
“This device complies with Industry Canada and Part
15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.”
The term “IC:” before the radio certifi cation number
only signifi es that Industry Canada technical specifi -
cations were met.
Changes or modifi cations to this device not express-
ly approved by the party responsible for compliance
with FCC regulations (the manufacturer) could void
the user’s authority to operate the equipment.
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a normal installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation.
Saris Cycling Group, Inc.
5253 Verona Rd.
Madison, WI 53711
800-783-7257
www.saris.com
www.cycleops.com
17946c 11/09
If this equipment does cause harmful interference
to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user
is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
difference from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV tech-
nician for help
To Previous Page
Loading...
