CYCLETOTE Utility Trailer-Small - Seat Post Hitch Attachment; Safety Features; Loading and Usage

skewer can be closed ghtly (press lever in, not around in a circle). Make sure wheels are very secure.
Wheel Reectors
Install the wheel reectors (if not already installed) into the wheels near the valve but with enough space to add air easily to the
res.
Seat Post Hitch
Aach the hitch to the seat post with the bevel facing upward at a height which
allows the trailer to be as parallel to the ground as possible. Open, then re-ghten
the hitch’s collar evenly on both sides of the seat post by screwing each bolt in part
way, and rotang between bolts as you ghten. Tighten the hitch to the seat post
so that it cannot move.
The ball joint is at the p of the tow bar. Feed the ball joint, top to boom, through
the hitch. The ball joint should rotate freely in the hitch.
Aaching Trailer to Seat Post Hitch
Spin the hitch nut onto the ball joint’s threads, with the teeth pressing against the hitch. Hand ghten rmly.
Rear Reectors
Install the rear reector on the mount at the rear center of the trailer. The oponal Blinky light can be mounted here instead.
Safety Strap
Wrap the safety strap around the seat post and aach, keeping it loose enough to avoid binding while cornering.
Safety Flag
Join the two pieces of the agpole to make a 6’ long pole. Insert the safety ag into the tube at the le rear of the trailer. The
movement of the ag draws drivers aenon and makes the trailer more visible.
Loading Your Trailer
Distribute the load evenly across the struts. We recommend strapping a board or hard plasc sheet to the oor of the trailer, or
using large plasc totes.
Owner’s Manual
Please read and understand your Owner’s Manual.
SMALL
TRAILER
Hitch
Safety Strap
Ball Joint
Tow Bar
Hitch Nut
2
 Tow bar (tongue)
 Seat post hitch –various
sizes
 Hitch nut
 Rack hitch
 Hex key 3/16
 Safety ag
 Safety Strap
 Red set screws
 Ball joint