Parts
Trailer frame
Seat post hitch
Two quick release wheels with
skewers and res
Two red set screws
Hitch nut
Rear reector
Two wheel reectors
Safety ag
Hex key
Tow bar & ball joint
Safety strap
Tow bar
Insert the two red set screws (wing nuts) into the threaded holes in the main frame
just far enough to hold them in place. Slide the tow bar downwards, between the
outer horizontal ring and the two notched front struts.
There are two grooves in the tow bar. Select the grooves that allow your trailer to
sit closest to level. Adjust the tow bar while you ghten the red set screws by hand
so that the screw ps t into the indentaons in the front of the tow bar.
When ghtened securely, the tow bar is pressed rmly against the struts to prevent
it from loosening.
Jogger Stroller
If you are installing the Jogger wheel, instead of the tow bar, follow Jogger Stroller
Instrucons which are a included separately, then return to Wheels.
Wheels
NOTE: If you have a braking system, skip this secon, go to the separately en-
closed Braking System Instrucons, and then return to Wheel Reectors.
Unwrap the quick release skewer, unscrew the nut and remove one spring. Then slide the skewer through the axle
of the hub (center of the wheel). Replace the spring with the smaller end towards the inside, and loosely aach the nut.
Set the wheel into the dropouts of the frame with the quick release skewer to the outside of the trailer. Tighten the nut unl the
Outer Horizontal
Ring
Drop Outs
hold wheel
Rail
Struts
Tow bar
Red Set
Screws
Reector
LARGE TRAILER
RING
Red Set Screw
Grooved strut
under fabric
Grooved strut
1
Skewer
To Next Page
Need help?
General