2. Mild Polish & Protectant – Mild deoxidizing agent specially formulated to bond to bare metal. Removes fine
polishing scratches only seen in direct sunlight. It also leaves a great protective coat that will prevent any further
oxidation.
Polishing:
1) After you have placed the pads or bonnets on your Cyclo tool, connect the tool to the power supply.
2) Apply a small amount (about a teaspoon) of the proper polish to each pad; small amounts repeatedly work better than large
amounts.
3) Place the twin-head Cyclo tool, pad side down on the surface and move the tool around before turning it on in order to
distribute the polish within the pad and over the surface.
4) Then, turn on the tool and move it back and forth and side to side across an area approximately 2.5 square feet in size. This
will spread the polish or deoxidizer across the surface in a latticed pattern.
5) Grip both handles of the polisher, and using moderate pressure - letting the action and the weight of the tool do the work -
move the polishing heads across the 2.5 square feet area under a comfortable speed. Deoxidize or polish the entire car in this
manner. When you have finished, rub out by hand the powdery residue left from the deoxidizer or smooth out any smudges left by
the glaze. Clean diapers are excellent for this.
6) If the residue does not wipe off easily, the surface is still not clean. Reapply a cleaning chemical to the area and rub it out.
7) Repeat steps 2-6 as necessary.
8) As the pads become badly impregnated with oxidation, they should be removed and washed. Never keep polish in pads
overnight.
Sanding:
Place two sanding jackets on your Cyclo tool and firmly press on two 4” sandpaper discs that are self-adhesive. Sanding discs can
be changed as needed.
Your Cyclo tool will handle all sanding jobs, including contour sanding. The job to be done will dictate the grade of sanding discs
to use.
Your Cyclo tool is excellent for wood and metal sanding...paint removal...orange peel removal...conditioning surfaces for
paint...floor sanding...all furniture sanding, contoured and flat...dry wall sanding. The Cyclo is a natural feather edger. It does an
exceptional job of feather edging on paint, metal or wood.
USER MAINTENANCE AND TROUBLESHOOTING
Motor:
Always be sure the Cyclo polisher/sander is disconnected from the electrical outlet before any inspection or maintenance is
performed.
The motor is only for the voltage specified on the nameplate. It is universal in that it can be used on either direct or alternating
current from 25 to 60 cycles. Voltage should not vary more than 10% over or under the voltage shown on the nameplate.
Although the Cyclo is built to last a lifetime it can encounter problems from heavy wear and tear. All problems are repairable, and
can most often be repaired by the user.
If the Cyclo tool has stopped:
7
To Next Page
Loading...