4 Push the TIRGGER, making the air pressure returning back to the bottle/cup. In
this way the air could circulate fluently.
Please note that you have to hold tightly and make the ALUMINUM TUBE no
rotating.
5 After using this method, you can see the water flowing from the INNER TUBE
without pushing the trigger. And then open the cup, water will stop flowing. It
means that the Cleaning Gun could operate normally. This way could be used for
all cleaning gun.
Maintenance:
In case of blocking or twist, switch off the Device immediately, disconnect the air
compressed source and do not switch on the Device again until the problem is
solved. Understand the reason why the Device has been blocked and make sure
that this situation will not occur once more.
In case of a malfunction or unusual vibration, switch off the device immediately
and provide the Device to an authorized service centre to check. If there is no
corrective action, the Device should not be in the use.
If this Device has any abnormality, then the Device can’t be in use until an
authorized server station fixes it. Keep in mind that many accidents are caused by
poor and inadequate maintenance.
Any worn-out part of this Device should be replaced by an original spare part. Get
in contact with your dealer or authorized service station for replacement support.
The use of unauthorized parts can cause malfunctions of this Device and injury to
personal health.
Check the Device regularly for cracks, unusual gap, mismatch and rotary parts
before in use of this Device.
To Next Page
Loading...