Operation
O Connect the air valve
A. Connect the nozzle directly to the valve
Adjust the nozzle mode and connect
it to the valve. Keep a tight grip on the
B. use the hose
Hold the hose and the suitable adapter,
then connect it to the valve,
it's recommended to use the hose when
using Schrader valve.
nozzle while inflating.
Note
Always loosen
the nut first.
For Schrader Valve
For Presta Valve
For Ball Valve
O Power on and set target air pressure
Long-press the Power button to power on,
and the screen illuminates, showing the
real-time air pressure reading,
Press '+' and together to switch between
PSI and BAR, Adjust target pressure using
and buttons The set pressure will display
for 3 seconds before reverting to current
pressure.
O Inflating
Press the Power Button to start inflation. It will auto
shut off when the target air pressure is reached,
O Shut down
Long-press the Power Button to power off If the air
pump is not started and there is no operation within
1 minute while it is powered on. the air pump will
automatically shut dowrL
03
Pressure
Value
Pressure
unit
Battery
To Next Page
Loading...
